Esterline CMA-9000 - After Hold Entry Initiated; Modifying an Existing Hold; Prior to Hold Entry

OPERATOR’S MANUAL
CMA-9000 FLIGHT MANAGEMENT SYSTEM
MODIFYING AN EXISTING HOLD
A. PRIOR TO HOLD ENTRY
1. Display the HOLD 1/X page by pressing [HOLD].
2. Modify the holding parameters.
HOLD page title line will display MOD HOLD.
3. Verify the new pattern parameters, and accept them by pressing [EXEC].
B. AFTER HOLD ENTRY INITIATED
1. Display the HOLD 1/X page by pressing [HOLD].
When the aircraft is in the holding pattern, the ACT HOLD page is displayed.
2. Modify the holding parameters.
The HOLD page title line will change from ACT HOLD to MOD HOLD.
3. Verify the new pattern parameters, and make them active by pressing [EXEC].
The HOLD page title line will change from MOD HOLD to HOLD.
NOTE: The new parameters become effective for navigation and guidance only on the next fly-over of the
holding fix, at which time the HOLD page title line will change from HOLD to ACT HOLD.
Page 10-9
August 17, 2010
DRAFT