Esterline CMA-9000 - Active Route Selection Using the User Route Name

OPERATOR’S MANUAL
CMA-9000 FLIGHT MANAGEMENT SYSTEM
ACTIVE ROUTE SELECTION USING THE USER ROUTE NAME
Display the RTE 1/X page by pressing the RTE function key.
1. Press the <USER RTES> prompt (LSK 5R) the USER ROUTES 1/X page is displayed.
2. Select from the USER ROUTES 1/X page the user route identifier, e.g.: KSEAPANC1.
The RTE 1/X page is re-displayed with the user route identifier displayed at the ROUTE field, LSK 3R.
"MOD" status is displayed in the title line. A "!WAIT" advisory message appears in the scratchpad while the
route information is being extracted from the navigation database.
3. Verify the ORIGIN and DEST identifiers.
4. Enter flight number into the scratchpad. Move to the FLT NO field by pressing LSK 2R.
5. Accept the new active route by pressing [EXEC].
"MOD" status in the title line changes to "ACT". The selected route is now active.
NOTE: When loading a user route in flight, the FMS will append a "+" to the user route identifier on the ROUTE
page thus indicating that the user route has been appended to the end of the current flight plan.
When a user route is inversed, the route name is preceded by the prefix INV in reverse video.
1R
2R
3R
4R
5R
MOD RTE 1 1/3
ORIGIN DEST
KSEA PANC
RUNWAY FLT NO
----- KL007
ROUTE
KSEAPANC1
CO RTES>
USER RTES>
OFFSET
<RTE 2 KJFK R0.0NM
1L
2L
3L
4L
5L
6L
6R
Page 3-11
August 17, 2010
DRAFT