Esterline CMA-9000 - VHF NAV DESELECT 1;1 Page (if VOR;DME Interfaces Are Configured

OPERATOR’S MANUAL
CMA-9000 FLIGHT MANAGEMENT SYSTEM
Page A-95
August 17, 2010
VHF NAV DESELECT 1/1 Page (if VOR/DME interfaces are configured)
Display VHF NAV DESELECT 1/1 page by pressing [INIT/ REF], <NAV STATUS>,<DME>, <DME_DESEL>; or
[INIT/ REF], <NAV STATUS>, <VOR/DME>, <VOR_DESEL>
A. This page enables the pilot to deselect VHF navaids for the DME/DME scanning and the VOR auto-tuning
logic.
ID [1L,2L,3L,4L,5L]: To add a station to the deselect list, type the identifier in the scratchpad and press a
softkey. To remove the station from the list, press CLEAR key and the corresponding softkey.
FREQ (1L, 2L, 3L, 4L, 5L): Displays DME frequency (MHz) in the second column.
TYPE (1R, 2R, 3R, 4R, 5R): Displays VHF navaid type in the third column (right justified). The navaid type can
be any of the following:
• DME
• ILSDME
• ILSTACAN
• LOCGS
• LOCONLY
• MLSDMEN
• MLSDMEP
• TACAN
• VNCDME
• VNCTACAN
• VOR
• VORDME
• VORTAC
DME STATUS [6L]: Access to DME STATUS 1/1 page. This prompt only appears if this page was accessed
from the DME STATUS page.
VOR/DME STATUS [6L]: Not shown in the page example. Access to VOR/DME STATUS 1/1 page. This
prompt only appears if this page was accessed from the VOR/DME STATUS page.
1R
2R
3R
4R
5R
6R
VHF NAV DESELECT 1/1
ID FREQ TYPE
YUL 116.30
MHZ VORDME
BIG 116.90
MHZ VORTAC
YMM 112.00
MHZ VORDME
IJFK 109.50
MHZ LOCGS
----
<DME STATUS
1L
2L
3L
4L
5L
6L
DRAFT