Esterline CMA-9000 - Route Selection from the List of User Routes

OPERATOR’S MANUAL
CMA-9000 FLIGHT MANAGEMENT SYSTEM
ROUTE SELECTION FROM THE LIST OF USER ROUTES
With the ACT or MOD RTE 1/X page displayed:
Display the user routes by pressing <USER ROUTES> (LSK 5R).
User routes are displayed left to right, in the order of entry.
1. Display the desired route by pressing [NEXT] or [PREV] as often as required.
2. Select route identifier by pressing the appropriate LSK.
3. Select the direction in which the route is loaded by toggling DIRECT/INVERSE using LSK 5L.
4. The RTE 1/X page is re-displayed. Verify the ORIGIN and DEST identifiers.
5. Accept the new active route by pressing [EXEC].
When airborne, selecting a user route will replace the destination with the selected user route destination
and will insert a discontinuity after the active waypoint followed by the selected user route waypoints. If a
procedure (for e.g. STAR or Approach) is part of the flight plan, the whole procedure is replaced by the
select user route.
1R
2R
3R
4R
5R
USER ROUTES 1/1
0001M0009M
WPT01WPT09
WPT01WPT10 STATION010
STATION015
----------
LOAD
>DIRECT
<ROUTE DELETE ALL>
1L
2L
3L
4L
5L
6L
6R
Page 3-12
August 17, 2010
DRAFT