OPERATOR’S MANUAL
CMA-9000 FLIGHT MANAGEMENT SYSTEM
MODE [3L,3R]: Displays mode status for the ADF radio. Pressing this softkey selects the next option. The
possible values are ADF and ANT if the ADF mode is configured for ADF and ANT operation. Otherwise, only
ADF mode is available.
BFO [4L,4R]: Displays mode status for the ADF radio. Pressing this softkey selects the next option. The
possible values are ON and OFF.
REL-BRG/MAG BRG/TRUE BRG [5L,5R]: Set and display of the ADF Bearing display mode and Bearing data.
At power on, the FMS will display the last ADF Bearing display mode setting prior to the last FMS power
interruption.
NOTE: The ADF does not provide bearing data while it's mode of operationis is set to "ANT".
RADIO [6L]: Access to the RADIO top level page where ADF is located.
LIBRARY [6R]: Access to the ADF Library page.
NAVIGATION RADIOS (ADF Page 2/2)
This page allows the pilot to control the operation of 2 ADF units.
NOTE: This page is only displayed if radio test is configured.
NOTE: This page may no longer be displayed once airborne if configured accordingly.
Display the second ADF RADIO page from the horizontal configuration by pressing [RADIO], <ADF#>.
NOTE: The ADF ident suffix "x" (e.g. ADF, ADF1...) and the side (left or right) where the ADF units appear
are depending on the installation configuration.
ADF1 TEST [5L]: Toggles ADF1 test status & results. Toggle options for test status are READY, CONFIRM?,
STARTED. Pressing LSK the first time causes CONFIRM? to appear the second press initiates the tests. Test
result is: PASS or FAIL or TIMEOUT.
ADF2 TEST [5R]: Same as above, but referencing ADF2 instead of ADF1.
RADIO [6L]: Access to the RADIO top level page where ADF is located.
ADF 2/2
ADF1 TEST ADF2 TEST
>READY READY<
<RADIO
Page 13-16
August 17, 2010
To Next Page
Loading...