OPERATOR’S MANUAL
CMA-9000 FLIGHT MANAGEMENT SYSTEM
VOR1/2 [XL]: Access to the VOR1/2 radio page.
VOR1/2 [XR]: Display and modify the VOR active and standby frequencies/ident/preset. Entry may be made to
the standby position only when a new value is in the scratchpad. If the scratchpad is empty it toggles
active/standby frequencies.
When auto-tuning mode is active, an inverse video ‘A’ is displayed next to the active ident/preset. Auto-tuning
mode is entered by assigning “DELETE” (press the [CLR] key) to the VOR standby frequency. Returning to
manual tuning mode requires “DELETE” (press the [CLR] key) to be assigned to the VOR standby frequency or
swapping of the active and standby VOR frequencies.
ILS [XL]: Access to the ILS/MLS radio page.
ADF1/2 [XL]: Access to the ADF1/2 radio page.
ADF1/2 [XR]: Display and modify the ADF active and standby frequencies/presets. When applicable, the ADF
status (e.g. ANT /BFO) is displayed in inverse video.
XPDR [XL]: Access to the XPDR/TCAS radio page.
XPDR [XR]: Used to display and modify the XPDR active and standby codes from the current active
transponder or from the last active transponder when toggled back to standby mode. Default value will be the
primary transponder at power-up (cold start) when both transponders are in standby mode.
NOTE: The X means a variable position. The Volume control and status location can differ based on the
number of radios and operator display configuration preferences. [1L] / [2L] / [3L] / [4L] / [5L] are other
possibilities where the Volume Control could be located.
The following acronyms are used: CTL=Controller, C1=VHF1, C2=VHF2, IC=InterCom, N1=VOR1,
N2=VOR2.
Page 13-5
August 17, 2010
To Next Page
Loading...