OPERATOR’S MANUAL
CMA-9000 FLIGHT MANAGEMENT SYSTEM
Page A-48
August 17, 2010
For LASEREF_V configuration:
C. When inertial in Attitude mode (SET IRS HDG field is displayed):
FMS POS [1L or 1R]: FMS present position. On power up, this corresponds to the last computed position stored
in the FMS. Manual entry is allowed (in DR modes only). The navigation mode is also displayed in white above
the position.
REF AIRPORT [2L]: Displayed when the FMS is configured for Fixed wing aircraft operations. Reference
airport; Valid entry is four character ICAO airport; Blank on liftoff; Entry deletes previous gate number.
REF AIRPORT coordinates (2R): Displayed when the FMS is configured for Fixed wing aircraft operations:
Reference airport coordinates. Displayed after valid entry in LSK 2L.
GATE [3L]: Displayed when the data has been loaded in the NDB. Gate entry possible only after valid airport
entry in LSK 2L. Blanks at liftoff or returns to dashes upon REF AIRPORT entry.
GATE coordinates (3R): Displayed when the data has been loaded in the NDB.. Displays after valid entry in
LSK 3L.
SET IRS POS [4R]: Inertial Sensor Initial Position entry field, enabled. LASEREF_V is configured. Boxes
displayed when any IRS in align mode. This field is automatically updated with the GPS position if there is no
GPS INTEGRITY alert upon acquisition of GPS position. Manual entry also allowed for as long as any IRS is in
align mode and GPS integrity not available (GPS HIL greater than 0.3 nm). Field (title and data) is blanked when
no IRS is in ALIGN mode.
POS INIT/REF 1/3
FMS POS GPS
N47
o
26.28 W122
o
18.67
REF AIRPORT
KBFI N47
o
31.80W122
o
18.00
GATE
BF1 N47
o
32.30W122
o
18.70
SET IRS HDG
UTC DATE
1757:04z DEC11/10
<SETUP ROUTE>
To Next Page
Loading...