EasyManua.ls Logo

Esterline CMA-9000 - Page 348

Esterline CMA-9000
561 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
OPERATOR’S MANUAL
CMA-9000 FLIGHT MANAGEMENT SYSTEM
Page A-86
August 17, 2010
ROUTE [1L,2L,3L,4L,5L,1R,2R,3R,4R,5R]: User Route name. When a name is entered from the scratchpad in
the field containing dashes, the CANCEL and CONFIRM prompts are displayed. Press CONFIRM in order to
save a new user route identical to the route that is being displayed on the RTE and LEGS pages. Pressing
[CLR], then the LSK key on a user route name will bring up the CANCEL and CONFIRM prompts. Press
CONFIRM for the deletion of that user route. Selecting a user route name with the scratchpad empty will bring
forth the RTE page with the selected user route loaded (but not activated).
NOTE: When airborne, a user route name selected on page USER ROUTES 1/1 will replace the current active
route without replacing the origin.
When a route name is entered over an existing one, the advisory message “!INVALID ENTRY” will be
displayed. In the case where an 11
th
route name would have to be entered (which is not allowed in the
system), one of the existing 10 route names has to be deleted in order to make room for that new route
since the maximum number of user routes is 10.
LOAD [5L]: Toggle DIRECT/INVERSE direction of the route to be loaded. DIRECT is the default.
ROUTE [6L]: Return to the RTE X 1/1 page.
DELETE ALL [6R]: Delete all user routes. Pressing this key causes the CANCEL and CONFIRM prompts to
appear. Press CONFIRM to delete. This prompt only appear if at least one user route exists.
(DELETE?): Displayed between the CANCEL/CONFIRM prompts upon deletion of a user waypoint.
CANCEL [6L]: Cancels the creation of a new user route or deletion of a single user route or of all user
routes, as applicable.
CONFIRM [6R]: Confirms the creation of a new user route or deletion of a single user route or of all user
routes, as applicable. Cross-talks the creation or deletion to the cross-side FMS if FMSs are in synchronized
mode.
NOTE: An advisory message “!USER ROUTE EXISTS” will be displayed if a duplicated name of user route is
entered. The entry will be rejected.
DRAFT

Table of Contents