OPERATOR’S MANUAL
CMA-9000 FLIGHT MANAGEMENT SYSTEM
When the installation provides for pressure altitude, PROGRESS 4/4 page fields LSK 6L or 6R display the
calculated mean sea level QNH for reference.
NOTE: The FMS will select and use the altitude from the priority list below:
• baro corrected altitude
• pressure altitude
• IRS baro-inertial altitude
• GPS altitude
For entries, units are automatically detected and decimal point entry is not required.
NOTE: This altimeter setting will be used until after landing, or until leaving the terminal area. The altimeter
setting is cancelled and the field displays dashes ("--.--") on leaving the terminal area (distance from
the departure airport is greater than 33 nm, or the altitude is greater than 16,000 feet above airport
elevation).
When no altimeter setting is defined, field displays boxes (.) on entering the terminal area
(distance from the destination airport is less than 30 nm, or the altitude is less than 15,000 feet above
airport elevation). This indicates a mandatory input is required.
Page 4-7
August 17, 2010
To Next Page
Loading...