Fujitsu Eternus DX80 S2 - Set Raid-Group

To Next Page

To Previous Page

Chapter 3 Configuration Settings and Display

3.3 RAID Group Management > set raid-group

ETERNUS CLI User’s Guide

114

set raid-group

This command changes the information of an existing RAID group.

■ Syntax

■ Parameter

set raid-group {-rg-number

rg_number

| -rg-name

rg_name

} [-name

name

]

[-assigned-cm {0|1|cm0cpu0|cm0cpu1|cm1cpu0|cm1cpu1| cm2cpu0|

cm6cpu0|cmc6pu1|cm7cpu0|cm7cpu1|auto}]

[-key-group {enable|disable}]

-rg-number

-rg-name

This parameter specifies RAID group identifiers.

Only one RAID group identifier can be specified when changing a RAID group alias name. One

or more RAID group identifiers can be specified when changing the assigned CM. For details,

refer to "1.2.8 RAID Group Syntax" (page 22)

-name Optional. This parameter specifies the new RAID group name. If this parameter is omitted, the

name is not changed. For details, refer to "1.2.4 Alias Name Syntax" (page 20)

-assigned-cm

Optional. This parameter specifies the assigned controller module number of the RAID group. If

"auto" is specified, the fixed controller, which is calculated automatically by the system, is

assigned. If this parameter is omitted, the assigned CM is not changed.

For the ETERNUS DX80 S2/DX90 S2:

0 Controller module#0

1 Controller module#1

auto Automatically (default)

For the ETERNUS DX410 S2/DX440 S2 and ETERNUS DX8100 S2:

cm0cpu0 Controller module#0 CPU#0

cm0cpu1 Controller module#0 CPU#1

cm1cpu0 Controller module#1 CPU#0

cm1cpu1 Controller module#1 CPU#1

auto Automatically (default)

Other manuals for Fujitsu Eternus DX80 S2