Fujitsu Eternus DX80 S2 - Delete Host-Sense

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > delete host-sense
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
302
delete host-sense
This command deletes (clears) the specified host sense.
■ Syntax
■ Parameter
■ Example(s)
delete host-sense
{-host-response-number
host_response_numbers | -host-response-name host_response_names }
-sense-number
sense_numbers
-host-response-number
or
-host-response-name
This parameter specifies host response identifiers to which the host sense to be deleted
belongs. The range is 1 to 127. One or more parameters can be specified at the same time. For
details, refer to "1.2.12 Host Response Syntax" (page 24)
.
-sense-number
This parameter specifies the host sense number that is to be deleted. The host sense number is
automatically registered in the system when the host sense conversion information is created.
Between 1 to 8 can be specified. The host sense number can be checked by using the "show
host-sense" command. One or more parameters can be specified at the same time.
The following example respectively deletes the host sense #1 corresponding to the host response #1 to #3:
CLI> delete host-sense -host-response-number 1-3 -sense-number 1