Fujitsu Eternus DX80 S2 - Show Host-Lu-Qos

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > show host-lu-qos
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
338
show host-lu-qos
This command displays the detailed setting information for the Host-LU QoS function.
■ Syntax
■ Parameter
show host-lu-qos [-mode {port-qos|host-qos|lu-qos}] [-port {xyz|all}]
[-host-type {fc|iscsi|sas} -host-number
host_number | -host-name host_name ]
[-lu-qos-group
lu_qos_group_number ]
-mode Optional. This parameter specifies which QoS settings are displayed.
port-qos Port QoS
host-qos Host QoS
lu-qos LU QoS
-port Optional. This parameter limits the QoS settings that are to be displayed to those that are
related to the specified port.
Example: -port 000
For details, refer to "1.2.14 Host Interface Port Syntax" (page 25)
.
xyz "x" is the controller module (CM) number, "y" is the CA number, and "z" is the host port
number.
Example: "123" indicates CM#1-CA#2-Port#3
all All the host interface ports
-host-type Optional. This parameter specifies the type of host to set Host QoS for. The host can be
specified by using the "-host-number" or "-host-name" parameter. Only one host type can be
specified at the same time.
fc FC/FCoE
iscsi iSCSI
sas SAS
-host-number
or
-host-name
Optional. This parameter limits the QoS settings that are to be displayed to those that are
related to the specified host. The "-host-type" parameter must also be specified to use this
parameter. For details, refer to "1.2.10 Host Syntax" (page 23)
.
-lu-qos-group
Optional. This parameter limits the QoS settings that are to be displayed to those that are
related to the specified LU QoS Group.