Chapter 4 Function/System Settings and Display
4.3 Network Management > set snmp-manager
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
473
set snmp-manager
This command sets an IP address to the snmp-manager setting.
This command is not available when the set SNMP manager setting is already used for a SNMP community or
SNMP trap.
■ Syntax
■ Parameter
■ Example(s)
set snmp-manager -manager-number
manager-number
-ip-address
ip_address
-manager-number
This parameter specifies the SNMP manager settings number. This number can be confirmed
by using the "show snmp-manager" command.
-ip-address This parameter specifies the SNMP manager IP address. To specify the SNMP manager IP
address, use IPv4 standard notation (a base 256 "d.d.d.d" string) or the IPv6 format. The SNMP
manager IP address cannot be specified with a fully qualified domain name (FQDN). The types
of IPv6 addresses that can be specified are global addresses (including 6to4 addresses), link
local addresses, and unique local addresses.
Example: -ip-address 192.168.1.20
Example: -ip-address fe80::1b:332f:d0
The following example sets SNMP manager number 3 to IP address 192.168.0.254:
CLI> set snmp-manager -manager-number 3 -ip-address 192.168.0.254
To Next Page
Loading...
