Fujitsu Eternus DX80 S2 - Set Password

Chapter 4 Function/System Settings and Display
4.1 User Management > set password
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
367
set password
This command changes the password of the specified user. This command prompts an operator for the new
password after command input.
■ Syntax
■ Parameter
■ Example(s)
set password [-name name ]
-name Optional. This parameter specifies the user account name to change a password. Only users
with the User Management policy can specify this parameter. Only one user name can be
specified at the same time. The new password is confirmed after command input. If omitted,
the password of the currently logged in user is changed.
The following example changes the password of the user account named "user1":
CLI> set password -name user1
Old Password :
New Password :
Confirm Password :