Fujitsu Eternus DX80 S2 - Show Subsystem-Parameters

Chapter 5 Information Settings and Display
5.4 Utility > show subsystem-parameters
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
674
show subsystem-parameters
This command displays the subsystem parameters.
■ Syntax
■ Parameter
No parameters.
■ Output
■ Example(s)
show subsystem-parameters
# Load Balance [Enable ]
A
# Reject INQUIRY from Unauthorized Host [Enable ]
B
# Thin Provisioning Allocation Mode [TPP balancing]
C
# Checkcode Enforcement Mode [Disable ]
D
# I/O Offloading (Current/After Power OFF ON) [Disable/ Enable]
E
A: It indicates if controlling load balance of the system is enabled.
B: It indicates if an INQUIRY command that is issued from an unauthorized host is accepted. (When an INQUIRY
command is set to be not accepted, the operation is the same as the response to an INQUIRY command with
an Affinity Error.)
C: It indicates if the current setting of the Thin Provisioning Allocation mode is enabled.
D: It indicates if the Checkcode Enhancement mode is enabled.
E: It indicates if the I/O Offloading is enabled for improving performance.
(This item is only displayed for the ETERNUS DX8700 S2. To enable I/O Offloading, restarting the ETERNUS DX
Disk storage system is necessary.)
The following example displays the subsystem parameters:
CLI> show subsystem-parameters
Load Balance [Disable ]
Reject INQUIRY from Unauthorized Host [Enable ]
Thin Provisioning Allocation Mode [TPP balancing]
Checkcode Enforcement Mode [Disable ]
I/O Offloading (Current/After Power OFF ON) [Disable/ Enable]