Fujitsu Eternus DX80 S2 - Set Host-Lu-Qos-Mode

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > set host-lu-qos-mode
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
327
set host-lu-qos-mode
This command sets up the Host-LU QoS function.
■ Syntax
■ Parameter
■ Example(s)
set host-lu-qos-mode -mode {enable|disable}
-mode This command specifies whether to enable or disable the Host-LU QoS function.
enable This parameter enables the Host-LU QoS function.
disable This parameter disables the Host-LU QoS function.
The following example enables the Host-LU QoS function:
CLI> set host-lu-qos-mode -mode enable
The following example disables the Host-LU QoS function:
CLI> set host-lu-qos-mode -mode disable