Fujitsu Eternus DX80 S2 - Set Ais-Connect

Chapter 4 Function/System Settings and Display
4.3 Network Management > set ais-connect
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
542
set ais-connect
This command sets up the AIS Connect operation environment. If the "REMCS function" is running or "E-mail
log send mode" is enabled, the AIS Connect function cannot be enabled.
■ Syntax
■ Parameter
set ais-connect
[-function {enable | disable}] [-port {maintenance | remote}] [-send-log {enable | disable}]
[-country-code
country-code ]
[-server-certification {enable | disable}]
[-proxy-server {
proxy-server | ""}] [-proxy-port-number proxy-port-number ]
[-proxy-type {http | socks}] [-user-name {
user-name | ""}]
-function Optional. This parameter specifies whether to enable the AIS Connect function. If omitted, the
existing setting is not changed.
enabled The AIS Connect function is enabled.
disable The AIS Connect function is disabled.
-port Optional. This parameter specifies which LAN port is used to communicate with the AIS Con-
nect server. This parameter cannot be specified when the AIS Connect function is disabled. If
omitted, the existing setting is not changed.
maintenance
MNT port
remote RMT port
-send-log Optional. This parameter specifies whether to automatically collect logs and send them to the
AIS Connect server when a failure (Error/Warning) occurs. This parameter cannot be specified
when the AIS Connect function is disabled or "Undefined" is displayed for "Service Contract
Responsibility" (the code of the country in which the support office for the ETERNUS DX Disk
storage system is located). If omitted, the existing setting is not changed.
enabled Logs are automatically sent.
disable Logs are not automatically sent.
-country-code
Optional. This parameter specifies the shipment destination of the ETERNUS DX Disk storage
system (the country where the ETERNUS DX Disk storage system is located). Specify a value
that is listed in "Country code list"
. This parameter cannot be specified when the AIS Connect
function is disabled. This parameter must be specified when the AIS Connect function is
enabled. If omitted, the existing setting is not changed.