Fujitsu Eternus DX80 S2 - Test Snmp-Trap

Chapter 4 Function/System Settings and Display
4.3 Network Management > test snmp-trap
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
502
test snmp-trap
This command sends an SNMP trap to the registered SNMP Manager for testing.
■ Syntax
■ Parameter
No parameters.
■ Example(s)
test snmp-trap
The following example sends the SNMP trap for testing:
CLI> test snmp-trap
The following example sends the SNMP trap to the SNMP Managers:
CLI> show snmp-trap
Trap SNMP Manager IP Community User Port
No. Version Number Address Name Name Number
1 v1 1 192.168.100.250 "community1" 162
2 v2c 2 192.168.2.1 "community2" 162
3 v3 3 10.0.0.1 "User1" 162
4 v3 4 192.168.100.101 "user_four" 8162
5 v3 1 192.168.100.250 "trap_user2" 162
CLI> test snmp-trap