Fujitsu Eternus DX80 S2 - Show Fcoe-Parameters

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > show fcoe-parameters
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
223
show fcoe-parameters
This command displays the parameters of each FCoE host interface port.
■ Syntax
■ Parameter
No parameters.
■ Output
show fcoe-parameters
# Port CM#0 CA#0 Port#0 CM#0 CA#0 Port#1 CM#0 CA#0 Port#2 CM#0 CA#0 Port#3
-> Each host interface port number
# Port Mode CA CA CA CA
-> Each port mode (CA)
# Transfer Rate 10Gbit/s 10Gbit/s 10Gbit/s 10Gbit/s
-> FC transfer rate (10Gbit/s)
# Frame Size 2048bytes 512bytes 2048bytes 2048bytes
-> FC frame size (512/1024/2048 byte)
# Host Affinity Disable Enable Disable Enable
-> Host affinity mode of each host interface port
# Host Response No. 5 6 7 8
# Host Response Name HP05 HP06 HP07 HP08
-> Host response number (The hyphen is shown when the host affinity mode is enabled.)
# Reset Scope I_T_L I_T_L I_T_L I_T_L
-> Range of reset action I_T_L (I: Initiator, T: Target, L: LUN) or T_L (T: Target, L: LUN)
# Reserve Cancel at Chip Reset Disable Enable Disable Enable
# FCF VLAN ID Disable Enable Disable Enable
55 100
-> FCF VLAN ID Enable/Disable and setting value.
#FCF Fabric Name Disable Enable Disable Enable
0001000100010001 0002000200020002
-> FCF Fabric Name Enable/Disable and setting value.