Fujitsu Eternus DX80 S2 - Show Event-Notification

Chapter 4 Function/System Settings and Display
4.3 Network Management > show event-notification
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
522
show event-notification
This command displays the parameters that have been set for event notification.
■ Syntax
■ Parameter
No parameters.
■ Output
show event-notification
# [Severity: Error Level] E-mail SNMP Host REMCS syslog AIS Connect
# Parts Error Notify Notify Notify(OPMSG) - Do not notify Notify
A B C D E F
# . . .
# Disk Error Notify(HS<0)
Notify(HS<0) Notify(HS<0,OPMSG) - Do not notify Notify(HS<0)
G H
A: It indicates whether it is notified by E-mail, or not.
B: It indicates whether it is notified by SNMP trap, or not.
C: It indicates whether it is notified by Host sense, or not. Also, it means host sense as OPMSG.
D: It indicates whether it is notified by REMCS, or not.
E: It indicates whether it is notified by syslog, or not.
F: It indicates whether it is notified by AIS Connect, or not.
G: It indicates conditions when there was no hot spare in the system.
H: It indicates conditions when there was no hot spare in the system. Also, it means host sense as OPMSG.