Chapter 4 Function/System Settings and Display
4.3 Network Management > show smi-s
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
529
show smi-s
This command displays whether the SMI-S functions are enabled or disabled.
■ Syntax
■ Parameter
No parameters.
■ Output
■ Example(s)
show smi-s
# Current [Enable]
A
# After the next power cycle [Enable]
B
A: It shows whether all of the SMI-S functions are currently enabled.
B: It shows whether all of the SMI-S functions will be enabled after the next power cycle.
The following example displays the SMI-S functions:
CLI> show smi-s
S
Current [Enable]
After the next power cycle [Enable]
To Next Page
Loading...
