Fujitsu Eternus DX80 S2 - Show Ntp

Chapter 4 Function/System Settings and Display
4.4 Miscellaneous > show ntp
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
560
show ntp
This command displays the NTP configuration.
■ Syntax
■ Parameter
No parameters.
■ Output
■ Example(s)
show ntp
CLI> show ntp
# NTP [Enable]
It shows whether the NTP function is enabled, or not.
# NTP Server [ntpserver.com]
NTP Server name
# NTP LAN Port [MNT]
Ethernet port to connect to NTP server
# Access Status [2008-02-21 08:30:00 succeeded SYNC]
Result of synchronization
The following example displays the NTP configuration:
CLI> show ntp
NTP [Enable]
NTP Server [10.1.1.100]
NTP LAN Port [RMT]
Access Status [2008-02-21 08:30:00 succeeded SYNC]
CLI> show ntp
NTP [Enable]
NTP Server [fd80::abd0:223:ad]
NTP LAN Port [RMT]
Access Status [0000-00-00 00:00:00 failed SYNC]
CLI> show ntp
NTP [Disable]
NTP Server [10.1.1.100]
NTP LAN Port [RMT]
Access Status [0000-00-00 00:00:00 succeeded SYNC]