Fujitsu Eternus DX80 S2 - Copy Affinity-Group

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > copy affinity-group
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
256
copy affinity-group
This command copies information from one affinity group to another affinity group.
■ Syntax
■ Parameter
■ Example(s)
copy affinity-group -name name
{-source-ag-number source_ag_number | -source-ag-name source_ag_name }
-name This parameter specifies the affinity group name of the target affinity group. Only one name
can be specified at the same time.
-source-ag-number
or
-source-ag-name
This parameter specifies the affinity group identifier which is the source of the copy. Only one
affinity group can be specified at the same time. For details, refer to "1.2.11 Affinity Group
Syntax" (page 24).
The following example copies the definitions contained in the affinity group named "AG001", and creates a
new affinity group named "AG002" with those same definitions:
CLI> copy affinity-group -name AG002 -source-ag-name AG001