Fujitsu Eternus DX80 S2 - Set Sed-Authentication

Chapter 4 Function/System Settings and Display
4.4 Miscellaneous > set sed-authentication
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
577
set sed-authentication
This command sets the authentication key for Self-Encrypted Disks (SEDs). SEDs are used to prevent the
leakage of data in case a disk is stolen or lost.
■ Syntax
■ Parameter
■ Example(s)
set sed-authentication -execution {yes|no}
-execution This parameter sets the authentication key for SEDs.
yes The authentication key for SEDs is set.
no The authentication key for SEDs is not set (default).
The following example sets the authentication key for an SED:
CLI> set sed-authentication -execution yes