Fujitsu Eternus DX80 S2 - Set Host-Wwn-Name

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > set host-wwn-name
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
229
set host-wwn-name
This command changes an existing FC or FCoE host identifier.
■ Syntax
■ Parameter
■ Example(s)
set host-wwn-name {-host-number host_number | -host-name host_name } [-wwn wwn ]
[-name
name ] [-host-response-number host_response_number |
-host-response-name
host_response_name ]
-host-number
or
-host-name
This parameter specifies the FC or FCoE host identifier to be changed. If only the host response
identifier is being set, then two or more FC or FCoE host identifiers can be specified at the same
time. If not, then only one can be specified. For details, refer to "1.2.10 Host Syntax" (page 23)
.
-wwn Optional. This parameter specifies the WWN to be changed. The WWN is a 16-byte
hexadecimal number. Only one parameter can be specified at the same time. If omitted, the
existing setting is not changed.
Example: -wwn 40000000abc78856
-name Optional. This parameter specifies the host WWN alias. Only one parameter can be specified at
the same time. For details, refer to "1.2.4 Alias Name Syntax" (page 20)
. If omitted, the
existing setting is not changed.
-host-response-number
or
-host-response-name
Optional. This parameter specifies the host response identifier to be changed. One or more
parameters can be specified at the same time. For details, refer to "1.2.12 Host Response
Syntax" (page 24). If omitted, the existing setting is not changed.
The following example changes the host response definition of the host named "HBA1":
CLI> set host-wwn-name -host-name HBA1 -host-response-number 2
The following example changes the host response definition of the FC hosts with consecutively numbered
identifiers #1 – #10 at the same time:
CLI> set host-wwn-name -host-number 1-10 -host-response-number 5
The following example changes the host named "HBA1". The new alias is "HBA123":
CLI> set host-wwn-name -host-name HBA1 -name HBA123