Fujitsu Eternus DX80 S2 - Import Ais-Ssl-Certificate

Chapter 4 Function/System Settings and Display
4.3 Network Management > import ais-ssl-certificate
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
553
import ais-ssl-certificate
This command imports and registers the SSL server certificate that is signed by the certificate provider.
■ Syntax
■ Parameter
■ Example(s)
import ais-ssl-certificate -port {maintenance | remote | fst} -server server_name -user login_user_account
-filename -filename [-indicator {enable | disable}]
-port This parameter specifies which Ethernet port is used to connect to the FTP server. For further
information, refer to "1.11 Note for Specifying FTP Server" (page 31)
.
maintenance
MNT port
remote RMT port
fst FST port (not supported in the ETERNUS DX80 S2/DX90 S2)
-server This parameter specifies the FTP server name in which the certificate file is to be stored. The
server name format is IPv4 standard notation (as a string in the base 256 notation d.d.d.d),
IPv6 address format or a fully qualified domain name (FQDN).
Example: -server 192.168.1.20
Example: -server fd80::abd0:223:ad
Example: -server foo.bar
-user This parameter specifies the user name that is to be used to access the FTP server. When this
parameter is specified, the command displays an FTP server password prompt.
-filename This parameter specifies the certificate file name.
-indicator Optional. This parameter specifies whether the progress indicator is displayed. If omitted, the
progress indicator is displayed.
enable Progress indicator is displayed.
disable Progress indicator is not displayed.
The following example imports and registers the signed certificate:
CLI> import ais-ssl-certificate -port maintenance -server ftp.example.com -user cli-user filename
server.cert
Password :