Fujitsu Eternus DX80 S2 - Create Snmp-User

Chapter 4 Function/System Settings and Display
4.3 Network Management > create snmp-user
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
483
create snmp-user
This command creates SNMP user settings.
■ Syntax
■ Parameter
■ Example(s)
create snmp-user -name user_name -view {mib_view_name|""} [-authentication {enable | disable}]
[-authentication-method {md5 | sha}] [-encryption {enable | disable}]
-name This parameter specifies the SNMP user name. Up to 10 SNMP user names can be specified. It
is a unique name. Between 8 and 32 characters can be specified for a name.
-view This parameter specifies the MIB view name. Up to 32 characters can be specified for a view
name. Specify double quotation marks ("") to not specify a view name.
-authentication
Optional. This parameter specifies whether to enable authentication. If it is specified, the "-
authentication-method" and "-encryption" options can be specified. In addition, the ETERNUS
DX Disk storage system confirms the authentication password. Between 8 and 64 characters
can be used for the password. If omitted, it is enabled.
enable Authentication is enabled (default).
disable Authentication is disabled.
-authentication-method
Optional. This parameter specifies which authentication method is used. One of the following
methods can be selected.
md5 MD5 (default)
sha SHA
-encryption Optional. This parameter specifies the encryption mode. If this parameter is set to enable, the
ETERNUS DX Disk storage system confirms the encryption password. Between 8 and 64
characters can be used for the password.
enable Encryption is enabled (default).
disable Encryption is disabled.
The following example creates the MIB user named "snmpuser1" with view "view13":
CLI> create snmp-user -name snmpuser1 -view view13
Authentication Password:
Confirm Authentication Password:
Encryption Password:
Confirm Encryption Password: