Chapter 3 Configuration Settings and Display
3.4 Volume Management > stop zero-reclamation
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
174
stop zero-reclamation
This command stops Zero Reclamation. To display the progress of a Zero Reclamation process that is stopped
by this command, use the "show volume-progress" command.
■ Syntax
■ Parameter
■ Example(s)
stop zero-reclamation {-volume-number
volume_number
| -volume-name
volume_name
}
-volume-number
or
-volume-name
This parameters specifies the volume number or alias name of a volume for which Zero
Reclamation is to be stopped. Multiple volumes can be set in a single command. For details,
refer to "1.2.9 Volume Syntax" (page 22)
.
The following example stops Zero Reclamation for a TFV that is named "FTV0001":
CLI> stop zero-reclamation -volume-name FTV0001
The following example stops Zero Reclamation for volumes #80 – #99 at the same time:
CLI> stop zero-reclamation -volume-number 80-99
To Next Page
Loading...
