Chapter 3 Configuration Settings and Display
3.3 RAID Group Management > show eco-raid-group
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
143
show eco-raid-group
This command displays a list of the ECO schedules that are associated with RAID groups.
■ Syntax
■ Parameter
No parameters.
■ Output
■ Example(s)
show eco-raid-group
# RAID Group Level Status Assigned Capacity ECO Schedule Motor Control
# No. Name CM (MB) Action No. Name Status Status
# 28
RGP028 RAID1 Available CM#0 53647 [ON ] 1 SC001 Active [OFF]
A B C D E F G H I J K
A: A RAID group number
B: A RAID group name
C: A RAID level
D: RAID group status
E: A Controller module to be assigned to a RAID group
F: RAID group capacity
G: An ECO schedule action, It means whether the ECO schedule is associated, or not
H: An ECO schedule number
(In the case of a schedule by a cooperative software, [128] is displayed.)
I: An ECO schedule name
(In the case of a schedule by a cooperative software, [External] is displayed.)
J: Current status of a Disk motor
K: Determent status by a control command
The following example displays a list of all the RAID groups that have an ECO schedule associated with them:
CLI> show eco-raid-group
RAID Group Level Status Assigned Capacity ECO Schedule Motor Control
No. Name CM (MB) Action No.Name Status Status
28 RGP028 RAID1 Available CM#0 53647 [ON ] 1 SC001 Active [OFF]
29 RGP029 RAID1+0 Available CM#0 60000 [ON ] 1 SC001 Active [OFF]
30 RGP030 RAID5 Available CM#1 89654 [OFF] 128 External Active [OFF]
31 RGP031 RAID0 Present CM#1 22301 [OFF] 2 SC002 Active [OFF]
To Next Page
Loading...
