Chapter 2 Status Display
2.1 Storage System Status > show fru-ce
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
41
show fru-ce
This command displays the status of components (Field Replaceable Units) of the controller enclosure.
■ Syntax
For the ETERNUS DX80 S2/DX90 S2, ETERNUS DX410 S2/DX440 S2, and ETERUS DX8100 S2:
For the ETERNUS DX8700 S2:
■ Parameter
■ Output
show fru-ce [-type {cm0|cm1|psu0|psu1}]
show fru-ce [-type {cm0 | cm1 | cm2 | cm3 | cm4 | cm5 | cm6 | cm7 | frt0 | frt1 | frt2 | frt3 | brt0 | brt1 |
brt2 | brt3 | brt4 | brt5 | brt6 | brt7 | svc0 | svc1 | psu0 | psu1 | psu2 | psu3 | psu4 | psu5}]
-type Optional. This parameter specifies the target component (FRU) name. The details and status of
each component embedded in the controller enclosure will be displayed. Only one parameter
can be specified. If this parameter is omitted, all of the FRUs are displayed.
ETERNUS For the ETERNUS DX80 S2/DX90 S2, ETERNUS DX410 S2/DX440 S2, and ETERNUS
DX8100 S2:
cm0 Details and status of the Controller Module Unit #0 and the sub-components
cm1 Details and status of the Controller Module Unit #1 and the sub-components
psu0 Details and status of the Power Supply Unit #0
psu1 Details and status of the Power Supply Unit #1
For the ETERNUS DX8700 S2:
cm0 to cm7 Details and status of the Controller Module Unit #n and the sub-components
frt0 to frt3 Details and status of the Front End Router #n
brt0 to brt7 Details and status of the Back End Router #n and the sub-components
svc0 to svc1
Details and status of the Service Controller#n
psu0 to psu5
Details and status of the Power Supply Unit#n
The following table shows the output information when the controller module and the sub-components are
specified:
CM#n Information (n: The controller module number)
CPU#n Status/Status Code
Controller Module (CM#n) status and the Status Code
To Next Page
Loading...
