Fujitsu Eternus DX80 S2 - Set Smi-S

Chapter 4 Function/System Settings and Display
4.3 Network Management > set smi-s
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
528
set smi-s
This command enables or disables the SMI-S functions.
■ Syntax
■ Parameter
■ Example(s)
set smi-s [-function {enable | disable}]
-function Optional. This parameter specifies whether all SMI-S functions are enabled or not. The initial
value is disabled. If omitted, the existing setting is not changed. To enable this parameter,
power cycle the system is required.
enable Each SMI-S function is enabled.
disable Each SMI-S function is disabled (default).
The following example disables all the SMI-S functions:
CLI> set smi-s -function disable