Fujitsu Eternus DX80 S2 - Show Diagnosis

Chapter 5 Information Settings and Display
5.4 Utility > show diagnosis
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
659
show diagnosis
This command displays either the bad data information for all of the volumes or for the specified volume(s).
■ Syntax
■ Parameter
■ Output
show diagnosis -type { disks [ -disks {all | disks} ] |
raid-groups [-rg-number
rg_numbers | -rg-name rg_names ] }
-type This parameter specifies the type of diagnostic results to be displayed. Only one type can be
displayed by a single command.
disks The diagnostic results of disks
raid-groups The diagnostic results of RAID groups
-rg-number
or
-rg-name
Optional. This parameter specifies the RAID group identifiers to be displayed and can only be
specified in conjunction with the "-type raid-groups" parameter. One or more RAID groups can
be specified at the same time. For details, refer to "1.2.8 RAID Group Syntax" (page 22)
. If
omitted, all the RAID groups are selected.
-disks Optional. This parameter specifies the disks to display more detailed diagnostic results of the
disks and can only be specified in conjunction with the "-type disks" parameter. One or more
disks can be specified at the same time. For details, refer to "1.2.3 Disk Syntax" (page 19)
. If
omitted, a summary list of all the disks is displayed.
all Detailed diagnosis results of all the disks.
Summary results of the disk diagnosis
Diagnosis Status
Diagnosis status
Progress Diagnosis progress
Method Diagnosis mode
Diagnosis Count
Loop count for diagnosis
Location Disk number
Diagnosis Status
Executing status
Result Diagnosis result