Fujitsu Eternus DX80 S2 - Copy Lun-Group

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > copy lun-group
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
265
copy lun-group
This command copies information from one LUN group to another LUN group.
■ Syntax
■ Parameter
■ Example(s)
copy lun-group -name name
{-source-lg-number source_lg_number | -source-lg-name source_lg_name }
-name This parameter specifies the LUN group name of the target LUN group. Only one name can be
specified at the same time.
-source-lg-number
or
-source-lg-name
This parameter specifies the LUN group identifier which is the source of the copy. Only one LUN
group can be specified at the same time. For details, refer to "1.2.11 Affinity Group Syntax"
(page 24).
The following example copies the definitions contained in the LUN group named "AG001", and creates a new
LUN group named "AG002" with those same definitions:
CLI> copy lun-group -name AG002 -source-lg-name AG001