Fujitsu Eternus DX80 S2 - Show Snmp-View

Chapter 4 Function/System Settings and Display
4.3 Network Management > show snmp-view
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
481
show snmp-view
This command displays a list of the registered SNMP MIB views. If MIB view names are specified, the
command displays the associated sub-trees.
■ Syntax
■ Parameter
■ Output
■ Example(s)
show snmp-view [-view view_names ]
-view Optional. This parameter specifies the MIB view name to display sub-trees. Two or more MIB
views can be specified by both a combination of a part of name and asterisk (*), a wildcard at
the same time and just scribing names. The wildcard rules are shown below:
Examples are shown below.
*: Correct
part-of-view-name*: Correct
*part-of-view-name: Incorrect
When the parameter is omitted:
# xview1
MIB view name
When requesting the SNMP MIB view:
When requesting the SNMP MIB view.
# View-name : xview4
A
# Subtree1 : [Include]
1.3.6.1.2.3
B C
# Subtree2 : [Exclude] 1.3.6.1.2.4
A: MIB view name
B: Sub-tree information, include/exclude
C: Sub-tree information, OID format sub-tree
The following example displays a list of all the registered MIB view names:
CLI> show snmp-view
"ViewALL"
"View-mib2"
"View-exmib"
"xview4"
"xview5"