Chapter 4 Function/System Settings and Display
4.2 Advanced Copy Management > show rec-disk-buffer
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
447
show rec-disk-buffer
This command displays a list of all of the REC disk buffers or displays only the REC disk buffers that are
specified by the REC buffer partition number(s).
Detailed information of the RAID group that is displayed when this command is used can be checked by using
the "show raid-groups" command.
■ Syntax
■ Parameter
show rec-disk-buffer [-partition
partition_numbers
]
-partition Optional. This parameter specifies the REC buffer partition number for REC disk buffers. One or
more numbers can be specified. If this parameter is specified, the CM-CPU information is also
displayed.
This number starts from 0. The selectable range is as follows:
ETERNUS DX90 S2: 0 to 3
ETERNUS DX410 S2/DX440 S2: 0 to 7
ETERNUS DX8100 S2/DX8700 S2: 0 to 7
Example:
-partition 1 (Only #1 is specified)
-partition 5,7 (Both #5 and 7 are specified)
-partition 2-5 (#2 through #5 are specified)
-partition 1,3,4-7 (#1, #3, and #4 through #7 are specified)
To Next Page
Loading...
