Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > show host-iscsi-names
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
247
show host-iscsi-names
This command displays a list of the iSCSI hosts registered in the system. When iSCSI host identifiers are
specified, iSCSI host details of the specified iSCSI host identifiers are displayed:
■ Syntax
■ Parameter
■ Output
show host-iscsi-names [-host-number
host_numbers
| -host-name
host_names
]
-host-number
or
-host-name
Optional. This parameter specifies which iSCSI host identifier(s) details are to be displayed.
One or more identifiers can be specified at the same time. If omitted, a summary list is
displayed. For details, refer to "1.2.10 Host Syntax" (page 23)
.
When the iSCSI host identifier parameter is omitted, then an iSCSI host summary list for all the iSCSI host
identifiers is displayed:
# Host Host Response IP Address iSCSI Name CmdSN Count
# No. Name No. Name
# 1
HBA-ISCSI-001 1 HP01 192.168.1.1 iqn.1991-05.com.microsoft 80
A B C D E F G
A: Host number
B: Host nickname
C: Assigned the host response number
D: Assigned the host response name
E: IP address which corresponds to a HBA. If the IP address is not specified, the * mark is displayed. When the IP
address format is IPv4, "*(IPv4)" is displayed. When the IP address format is IPv6, "*(IPv6)" is displayed.
F: iSCSI host name which corresponds to a HBA
G: CmdSN Count
When iSCSI host identifiers are specified, iSCSI host details of the specified iSCSI host identifiers are
displayed:
# Host No. 1
# Host Name HBA1
# iSCSI Name iqn.1991-05.com.microsoft
# Alias Name IQN-DXL1
# IP Address 10.1.1.1
# Chap User Name User01
# Host Response No. 0
# Host Response Name Default
# CmdSN Count Unlimited
To Next Page
Loading...
