Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > show lu-qos-groups
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
331
show lu-qos-groups
This command displays detailed settings of the LU QoS Group.
■ Syntax
■ Parameter
■ Output
show lu-qos-groups [-lu-qos-group
lu_qos_group_number
] [-lun
lun
|all]
-lu-qos-group
Optional. This parameter specifies the LU QoS Group to display detailed information.
-lun Optional. This parameter specifies which Host LUNs to display detailed information for.
When "all" is specified, the information for the LUNs with "0" (Unlimited) as the Bandwidth
Limit is also displayed. If omitted, the information for the LUNs with "0" (Unlimited) as the
Bandwidth Limit is not displayed.
When a list of the LU QoS Groups is displayed
#CLI> show lu-qos-groups
#LU QoS Group
#No.
# 0
# 1
# 2
A
A: Registered LU QoS Groups
When the LU QoS Groups to display detailed information for are specified
# LU QoS Group No.1
# LUN Bandwidth Limit
# 3 1
# 4
14
A B
# LU QoS Group No.2
# LUN Bandwidth Limit
# 6
1
A B
A: Registered LU QoS Groups
B: Bandwidth Limit value that is set to the LU QoS Group
To Next Page
Loading...
