Fujitsu Eternus DX80 S2 - Show Ca-Reset-Group

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > show ca-reset-group
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
306
show ca-reset-group
This command displays a list of the host interface ports that are in each of the reset groups. The number of
reset groups is dependent on the number of host interface ports available.
■ Syntax
■ Parameter
No parameters.
■ Output
■ Example(s)
show ca-reset-group
The following example displays a system that has 4 host interface ports:
# Port
# Reset Group 000 001 002 003
# Reset Group 100 101 102 103
A A A A
A: Host interface port #0 in the reset group
The following example shows each reset group configured with four host interface ports:
CLI> show ca-reset-group
Port
Reset Group 000 001 002 003
Reset Group 010 011 012 013
Reset Group 100 101 102 103
Reset Group 110 111 112 113
The following example shows a reset group that is configured with 16 host interface ports:
CLI> show ca-reset-group
Port
Reset Group 000 001 002 003 010 011 012 013 100 101
102 103 110 111 112 113