Fujitsu Eternus DX80 S2 - Show Eco-Thin-Pro-Pool

Chapter 3 Configuration Settings and Display
3.1 Thin Provisioning Pool Management > show eco-thin-pro-pool
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
90
show eco-thin-pro-pool
This command displays the list of ECO schedules that are associated with Thin provisioning pools.
■ Syntax
■ Parameter
No parameters.
■ Output
■ Example(s)
show eco-thin-pro-pool
#Thin Pro Disk reli- Status ECO Schedule Motor Control
#No. Name attri- ability Status Status
# bute Action No. Name
#00
TPP01 Online High Available [ON] 1 SC001 Active [OFF]
A B C D E F G H I J
A: Thin provisioning pool number
B: Thin provisioning pool name
C: Disk attribute that composes the Thin provisioning pool (Online/Nearline)
D: Reliability of the Thin provisioning pool (High/Middle/None)
E: Thin provisioning pool status
F: ECO schedule action. Whether the ECO schedule is associated is displayed.
G: ECO schedule number
(In the case of a schedule by a cooperative software, [128] is displayed.)
H: ECO schedule name
(In the case of a schedule by a cooperative software, [External] is displayed.)
I: Current status of a disk motor
J: Control status by a control command
The following example displays a list of all the Thin provisioning pools that have an ECO schedule associated
with them:
Thin Pro Disk reli- Status ECO Schedule Motor Control
No. Name attri- ability Status Status
bute Action No. Name
00 TPP01 Online High Available [ON] 1 SC001 Active [OFF]
01 TPP02 Online Middle Available [ON] 2 SC002 Active [OFF]
05 TPP05 Online High Available [ON] 5 SC005 Active [OFF]