Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > show fcoe-parameters
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
224
■ Example(s)
The following example shows the parameters displayed for each FCoE interface port.
In this example, each CA has 2 ports and each CM has 2 CAs:
CLI> show fcoe-parameters
Port CM#0 CA#0 Port#0 CM#0 CA#0 Port#1
Port Mode CA RA
Transfer Rate 10Gbit/s 10Gbit/s
Frame Size 2048bytes 2048bytes
Host Affinity Enable Enable
Host Response No. 1 2
Host Response Name HP01 HP02
Reset Scope I_T_L I_T_L
Reserve Cancel at Chip Reset Disable -
FCF VLAN ID Disable Disable
FCF Fabric Name Disable Disable
Port CM#0 CA#1 Port#0 CM#0 CA#1 Port#1
Port Mode CA CA
Transfer Rate 10Gbit/s 10Gbit/s
Frame Size 2048bytes 2048bytes
Host Affinity Enable Enable
Host Response No. - -
Host Response Name
Reset Scope I_T_L I_T_L
Reserve Cancel at Chip Reset Disable Enable
FCF VLAN ID Enable Enable
55 100
FCF Fabric Name Enable Enable
0001000100010001 0002000200020002
Port CM#1 CA#0 Port#0 CM#1 CA#0 Port#1
Port Mode CA CA
Transfer Rate 10Gbit/s 10Gbit/s
Frame Size 1024bytes 1024bytes
Host Affinity Disable Disable
Host Response No. 3 4
Host Response Name HP03 HP04
Reset Scope I_T_L I_T_L
Reserve Cancel at Chip Reset Disable Enable
FCF VLAN ID Disable Disable
FCF Fabric Name Disable Disable
Port CM#1 CA#1 Port#0 CM#1 CA#1 Port#1
Port Mode CA CA
Transfer Rate 10Gbit/s 10Gbit/s
Frame Size 1024bytes 1024bytes
Host Affinity Disable Enable
Host Response No. - -
Host Response Name
Reset Scope I_T_L I_T_L
Reserve Cancel at Chip Reset Disable Enable
FCF VLAN ID Enable Enable
56 101
FCF Fabric Name Enable Enable
0003000300030003 0004000400040004
To Next Page
Loading...
