Fujitsu Eternus DX80 S2 - Page 281

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > show host-affinity
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
281
■ Example(s)
When a host affinity is set for the port group (Host Affinity Mode is disabled)
# Port Group Host Response Affinity/LUN Group
# No. Name No. Name No. Name
# 4
FCoEPG#0 250 Solaris MPxIO 10 ag2
A B C D E F
# <Port List>
# CM#1 CA#1 Port#0
G
# CM#1 CA#1 Port#1
A: Port group number
B: Port group name
C: Host response number
D: Host response name
E: Affinity group number or LUN group number
F: Affinity group name or LUN group name
G: Port number
The following example displays all of the existing mappings:
CLI> show host-affinity
Port Group Host Group Affinity/LUN Group Multi-Group
No. Name No. Name No. Name Volumes
1 pg1 0 hg 0 ag1 No
<Connection List>
Port Host
No. Name
CM#0 CA#0 Port#0 -
CM#0 CA#0 Port#1 0 A
CM#0 CA#0 Port#1 1 B
Port Group Host Group Affinity/LUN Group Multi-Group
No. Name No. Name No. Name Volumes
2 pg01 1 FCoE 1 ag2 No
<Connection List>
Port Host
No. Name
CM#0 CA#0 Port#0 -
CM#0 CA#0 Port#1 7 FCoE#2
Port Group Host Response Affinity/LUN Group
No. Name No. Name No. Name
4 FCoEPG#0 250 Solaris MPxIO 10 ag2
<Port List>
CM#1 CA#1 Port#0
CM#1 CA#1 Port#1
CM#0 CA#0 Port#0 (Host Affinity Mode Enable)
Host Affinity/LUN Group Multi-Group
No. Name No. Name Volumes
8 FCoE#3 0 ag1 No
CM#0 CA#0 Port#1 (Host Affinity Mode Enable)
CM#1 CA#1 Port#0 (Host Affinity Mode Disable)
CM#1 CA#1 Port#1 (Host Affinity Mode Disable)