Fujitsu Eternus DX80 S2 - Page 342

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > show host-lu-qos
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
342
The following example displays the details of the Port QoS settings:
CLI> show host-lu-qos -mode port-qos -port 000
Port Bandwidth Limit
CM#0 CA#0 Port#0 0
<Event>
No. Schedule No. Bandwidth Limit
1 10 5
2 20 8
5 30 10
The following example displays the Host QoS settings:
CLI> show host-lu-qos -mode host-qos
Host Bandwidth Limit Host Type WWN/iSCSI Name/SAS Address
No. Name
0 Host#FC_0 0 FC/FCoE AABBCCDDEEFF0001
1 Host#FC_1 1 FC/FCoE AABBCCDDEEFF0011
2 Host#SAS_0 4 SAS FFAABBCCDDEE0011
0 Host#iSCSI_0 5 iSCSI iqn.1991-05.com.microsoft
The following example displays the details of the Host QoS settings:
CLI> show host-lu-qos -mode host-qos -host type iscsi -host-number 0
Host Bandwidth Limit Host Type WWN/iSCSI Name/SAS Address
No. Name
0 Host#iSCSI_0 5 iSCSI iqn.1991-05.com.microsoft
<Event>
No. Schedule No. Bandwidth Limit
1 2 3
3 4 14
The following example displays the LU Host-LU QoS settings:
CLI> show host-lu-qos -mode lu-qos
Port (Bandwidth Limit) Host (Bandwidth Limit) LUN (Bandwidth Limit)
No. Name
CM#0 CA#0 Port#0 ( 0) 0 Host#FC_0 ( 0) 0 (0)
CM#0 CA#0 Port#0 ( 0) 0 Host#FC_0 ( 0) 1 (0)
CM#0 CA#0 Port#0 ( 0) 0 Host#FC_0 ( 0) 2 (0)
CM#0 CA#0 Port#0 ( 0) 2 Host#FC_1 ( 1) 0 (5)
CM#0 CA#0 Port#0 ( 0) 2 Host#FC_1 ( 1) 1 (5)
CM#0 CA#0 Port#0 ( 0) 2 Host#FC_1 ( 1) 2 (5)