Chapter 4 Function/System Settings and Display
4.3 Network Management > set snmp-view
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
479
■ Example(s):
-exclude-subtree
Optional. This parameter specifies the "exclude" subtree type. A value between 1 and 10 can
be specified for the subtree number. Two or more subtree numbers can be specified by using
"," or "-".
If this parameter and the "-include-subtree" parameter are omitted, "include" is used as the
default for subtree.
The following example adds the sub-tree named "1.3.6.1.2.8" to the MIB view named "xview4":
CLI> set snmp-view -view xview4 -subtree2 1.3.6.1.2.8
The following example deletes the sub-tree #1 from the SNMP view named "xview5". For example, sub-tree
#2 is newly relocated as sub-tree #1:
CLI> set snmp-view -view xview5 -subtree1 ""
The following example changes the sub-tree #4 of "xview1" from "include" to "exclude":
CLI> set snmp-view -view xview1 -exclude-subtree 4
To Next Page
Loading...
