Chapter 4 Function/System Settings and Display
4.3 Network Management > show email-notification
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
512
■ Example(s)
A: E-mail send mode
B: Ethernet port
C: SMTP server name
D: Access port number to an SMTP server
E: SMTP authentic method
F: User name for SMTP authentication
G: Sender of E-mail address
H: E-mail address sent from the system
I: The fixed messages included in E-mail message
J: Retry count
K: Retry interval (seconds)
L: Timeout value (seconds)
M: Partial mode. enable/disable
N: Partial size (KB)
O: E-mail log send mode. It displays only the models that do not support REMCS.
P: I/O module log send mode. It displays only the models that do not support REMCS.
Q: Customer information send mode. It displays only the models that do not support REMCS.
The following example displays the parameters related to E-mail notification setup:
CLI> show email-notification
Send E-Mail Enable
Port MNT
SMTP Server foo1.bar1
SMTP Port No 25
Authentication Auto
User Name profile
From foo2@bar2
To1 foo1@bar1
To2 foo2@bar2
To3 foo3@bar3
To4 foo4@bar4
To5
Text1 Hello
Text2 This is the ABC.
Text3 Thank you.
Retry Count 1
Retry Interval(sec) 4
Timeout(sec) 30
Partial mode Disable
Partial size(KB) 64
Send Log Enable
I/O Module Log Enable
Customer info Enable
To Next Page
Loading...
