Appendix A Error Messages
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
689
E0014 Inconsistent disk status.
Cannot execute the specified command because the disk is not in an appropriate state. Check the status
of the disks identified in the details of this message.
E0015 Inconsistent enclosure status.
Cannot execute the specified command because the enclosure is not in an appropriate state. Check the
status of the disks identified in the details of this message.
E0019 Inconsistent parameter.
The specified parameter does not correspond with the command. Check the parameters indicated in the
details of this message.
E0020 Internal error.
An internal error has occurred. Retry the command, and if unsuccessful, contact the support department.
E0021 The requested operation has failed.
The specified command process has failed. If this error continues to recur even after numerous command
retries, the specified command cannot be executed for an unknown reason.
E0030 Command not supported.
This command is not supported. Check the execution conditions (Example: model type, host interface
type (FC/SAS/iSCSI), and firmware levels).
E0031 Reserved keyword is used.
Reserved keyword cannot be used. Use another name.
E0032 Controller firmware cannot be downgraded.
Reverting to an earlier version is not allowed for the hot application mode. Confirm the controller
firmware version by using the "show firmware" command, and use the cold application mode if necessary.
E0033 Not applicable to this target.
The specified resource cannot be applied to the specified command process. Check the specified resource.
E0034 Mainframe resources.
The specified Mainframe resource cannot be applied to the specified command process. Check the
specified resource.
E0035 Disk firmware can only be upgraded.
Confirm the firmware version that is registered in the ETERNUS Disk storage system and the firmware
version that has been applied to the disks. The disk firmware that is currently being used can only be
upgraded to a newer version.
E0041 Incorrect password syntax.
The syntax of the specified password is incorrect. Check that the length and characters of the passwords
are acceptable.
E0042 Incorrect password.
The password entered is incorrect. Check and then re-enter the password.
E0050 Incorrect file.
The specified file format is incorrect. Check the format of the file identified in the details of this message.
E0051 Incorrect license key.
The specified license key is incorrect. Check the license key shown in the details of this message.
E0052 File access failure.
Unable to access the specified file. Possible causes include file restrictions, directory restrictions or a lack
of free space when creating a file.
Message
number
Message
Countermeasure for the error
To Next Page
Loading...
