Appendix A Error Messages
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
701
E5207 Exist volume(s) of protection from copy destination.
Copy destination volumes with protection settings exist.
E5208 Copy license information updating due to trial license expired.
The copy license information is being updated. Wait for a while and try again.
E5209 Not support E6K to target of REC.
Consistency sessions are not supported for remote storage systems.
E5210 Data in disk buffer.
Data exists in the disk buffer. Check the disk buffer by using the "show rec-buffer" command.
E5211 The raid group is for REC disk buffer.
The specified RAID group is configured with an REC disk buffer. Check the RAID group by using the "show
rec-disk-buffer" command.
E5212 Source and destination RA type is not match.
The RA type does not match for the copy source and copy destination devices in the REC path settings.
Check the contents of the settings for the path file.
E5213 The times registering trial license has been reached the system limit.
The limit for the number of times that the trial license can be registered has been reached.
E5214 Exist RA.
The RA is set. Check the RA by using the "show host-port-mode" command.
E5501 iSNS server cannot be connected from the specified iSCSI CA port.
The iSNS server is not set for the specified iSCSI CA port.
E5701 The factory setup is not done.
The factory settings have not been performed.
E6000 Advanced Copy session that covers the entire volume is active.
An Advanced Copy session that affects the entire volume is being performed.
E6001 The specified volume is ODX Buffer Volume.
The specified volume is an ODX Buffer volume.
E6002 The specified volume is volume during Zero Reclamation execution.
The specified volume is a volume that is currently undergoing Zero Reclamation.
E6003 Offloaded Data Transfer Mode is valid.
The Offloaded Data Transfer mode is enabled.
E6004 Offloaded Data Transfer Mode is not valid.
The Offloaded Data Transfer mode is disabled.
E6005 ODX Buffer Volume exist.
ODX Buffer volumes exist.
E6006 The specified volume is not ODX Buffer Volume.
The specified volume is not an ODX Buffer volume.
E6007 Offloaded Data Transfer in process.
An Offloaded Data Transfer is in progress.
E6008 The specified volume is not volume during Zero Reclamation execution.
The specified volume is a volume that is currently not undergoing Zero Reclamation.
E6009 Not available under operating Bind-in-Cache.
The specified command cannot be executed because Bind-in-Cache is set.
Message
number
Message
Countermeasure for the error
To Next Page
Loading...
