Fujitsu PRIMERGY TX120 S3 - Installing a 3.5-Inch HDD Module; Concluding Steps

142 Upgrade and Maintenance Manual TX120 S3
Hard disk drives / solid state drives
7.3.4.4 Installing a 3.5-inch HDD module
Ê Install the replacement HDD module into the empty drive bay as described
in section "Installing a 3.5-inch HDD module" on page 132.
7.3.4.5 Concluding steps
Perform the following procedures to complete the task:
Ê Please observe the notes on RAID rebuild in section "Performing a RAID
array rebuild" on page 104.
Ê Close the front cage as described in section "Closing the front cage" on
page 68.
Ê Cose the server cover as described in section "Mounting the server cover"
on page 72.