238 Upgrade and Maintenance Manual TX120 S3
Main memory
10.2.4 Concluding steps
Perform the following procedures to complete the task:
Ê Close the server cover as described in section "Closing the server" on
page 70.
Ê Reconnect the AC power cord to the power supply unit as described in
section "Connecting the server to the mains" on page 73.
Ê Update the system board BIOS to the latest version as described in section
"Updating or recovering the system board BIOS and iRMC" on page 86.
Ê Enable boot watchdog functionality as described in section "Enabling SVOM
boot watchdog functionality" on page 96.
Ê If applicable, configure the memory mode as described in section "Verifying
the memory mode" on page 98.
Ê If BitLocker functionality is used and has been disabled before starting the
maintenance task, re-enable BitLocker as described in section "Enabling
BitLocker functionality" on page 103.
To Next Page
Loading...
Need help?
General