78 Upgrade and Maintenance Manual TX120 S3
Basic hardware procedures
4.10 Concluding software tasks
Ê Perform the following software tasks to put the server back in operation:
– "Resetting the boot retry counter" on page 94
– "Verifying the system time settings" on page 99
– "Viewing and clearing the System Event Log (SEL)" on page 100
– "Updating the NIC configuration file in a Linux environment" on
page 101
– "Enabling BitLocker functionality" on page 103
– "Performing a RAID array rebuild" on page 104
– "Looking up changed MAC / WWN addresses" on page 104
– "Configuring LAN teaming" on page 83