Fujitsu PRIMERGY TX120 S3 - Backup Drive; Installing Backup Drive; Required Tools; Preliminary Steps

280 Upgrade and Maintenance Manual TX120 S3
Accessible drives
12.3 Backup drive
12.3.1 Installing backup drive
12.3.1.1 Required tools
● Preliminary and concluding steps: toolless
● Removing accessible drives:
– Phillips PH2 / (+) No. 2 screw driver
12.3.1.2 Preliminary steps
Before installing an accessible drive, perform the following steps:
Ê Disable BitLocker functionality as described in section "Disabling BitLocker
functionality" on page 79.
Ê Shut down the server as described in section "Shutting down the server" on
page 58.
Ê Disconnect the AC power cord from the system.
Ê Remove the server cover as described in section "Opening the server" on
page 61.
Upgrade and Repair Units (URU)
Average task duration: 10 minutes